
Order your Bike 2x2 NOW
The most cross-country electric vehicle on the planet Earth. Low-pressure tires provide phenomenal cross-country capability on both land and water.
Order nowFind out what our Ultra 2x2 Bike can do
-
motorcycle
4WD
2 x 1000W 48V Motors
> Brushless DC air cooled.
> High durability planetary geared system.
> Fully splined gear interfaces.
> Sealed bearings.
> Active heat management.
> Active venting for residual moisture.Brushless DC air cooled.
> High durability planetary geared system.
> Fully splined gear interfaces.
> Sealed bearings.
> Active heat management.
> Active venting for residual moisture.
These electric motors provide the maximum torque needed to tackle difficult off-road terrain.
-
Wheels
Low pressure tires
>Specific ground pressure - 0.3 kg/cm²
> 2 layers of rubber
> Metal grouser plates
Due to the larger volume, our wheels have positive buoyancy, which allows you to overcome water obstacles swimming. It is not easy to puncture these wheels, because they create minimal pressure on the ground. The same property of our wheels allows you to move with confidence on swampy and sandy terrain and overcome deep snow drifts.
-
Generator
Gasoline generator on board
> Voltage 220V
> Manual starter
> Max power, kW 0.85
> Weight 9kg
The frame of our 2x2 Bike allows the location of a portable gasoline generator for when you plan a long trip and need unlimited range. The built-in battery charger recharges the battery while the generator is running, allowing you to have virtually unlimited range. The generator can always be easily removed and the bike can be used without it, only on batteries.
-
Fuel tanks
Fuel tanks in wheels
> Tank volume in each wheel 20 L
Tanks are fully sealed. Allows you to store and transport fuel for the generator or drinking water. The total volume of fuel reserve is 40l. Each tank has two holes for draining and pouring fuel.
-
Charger
Onboard charger
> Charging capacity - 1500W
> Adjustable charging current 15-30A
> Charging voltage 48V
> Full charging time - 1 hour
A built-in pulse charger with adjustable charging current is available on board. It allows the battery to be recharged from a running alternator while driving or while parked with up to 15 amperes of current. Or it is possible to charge from the 110/220V electric network in accelerated mode in 1 hour.
-
Invertor
Inverter on board
> Input voltage 48V
> Output voltage 110/220V
> Power 3000W
From our 2x2 Bike you can power electric tools and other electrical appliances up to 3000W in the field.
-
Lifepo4
Lifepo4 battery
> Lifepo4 chemistry type
> Rated voltage 48V
> Capacity 1.6KWh
> More than 2000 cycles
> 50km range
> Maximum discharge current 150A
> Maximum charging current 60A
> Absolutely no memory effect
> Operable from -20℃ to +60℃
> Low self-discharge
> Built-in BMS protection circuit board
> Built-in passive balancers
Lightweight, compact and durable lithium-iron-phosphate LiFePO4 battery 48V 30Ah. Assembled from sixteen 3.2V 30Ah cells connected in series. For stable, reliable and durable battery is installed symmetrical BMS board, which protects the battery from overcharging and overdischarging, provides cell balancing. The battery is equipped with a protective textolite casing in heat shrink, which provides protection against dust and moisture (IP44). The battery is non-flammable and contains no toxic substances. The battery withstands 2,000 charge/discharge cycles up to a 20% capacity loss in harsh operation, and up to 8,000 cycles in gentle mode.
-
Balloons
Supporting cylinders
For navigating fords and light water obstacles, our 2x2 Bike has positive buoyancy. But it needs supportive cylinders on the sides to stay firmly in the water.
Pumping is performed by a compressor from 12V on-board network
-
Lighting
LED optics
Dual LED headlights at the front, LED taillights at the rear. Turn indicators. Steering wheel controls.
12V on-board system.
-
Brakes
Hydraulic brake system
> Hydraulic & regenerative brakes operate together.
> Active regenerative braking (brake activated):
– Independent front and rear brake control.
> Passive regenerative braking (off throttle).
DOT approved hydraulic brakes.
190 x 2.3mm rotors.
Our 2x2 Bike has a hydraulic brake system on both wheels. Brake disc diameter of 190mm. Hydraulic brake caliper.

2x2 Ultra Bike. Sand test.

2x2 Ultra Bike. Snow test.

2x2 Ultra Bike. Full review.

2x2 Ultra Bike. Mud test.
Dimensions
Weight excl. power supply: 60.7kg | 133lbs
Height: 1,040mm | 41”
Seat height: 750mm | 29”
Width (handlebars): 820mm | 32.3”
Length: 2,100mm | 82”
Wheelbase: 1400mm | 55”
Performance
Max speed: 50km/h | 30mph (45km/h EU).
High torque geared drivetrain.
Drive train
2 x 1kw motors:
> Brushless DC air cooled.
> High durability planetary geared system.
> Fully splined gear interfaces.
> Sealed bearings.
> Active heat management.
> Active venting for residual moisture.
Brakes
> Hydraulic & regenerative brakes operate together.
> Active regenerative braking (brake activated):
– Independent front and rear brake control.
> Passive regenerative braking (off throttle).
DOT approved hydraulic brakes.
190 x 2.3mm rotors.
Structure
Payload (incl. rider): 150kg | 330lbs
Mechanically switched self-retaining kickstand.
Suspension
2x2 Bike rear suspension:
> Coil over spring with hydraulic dampener.
> Preload & rebound adjustment.
User Controls
Fully electronic throttle control.
Handlebar mounted momentary switch controls for hi/lo-beam, indicators, and horn.
Streamlined dashboard view with LCD display.
The ability to disable either front or rear wheel drive.
Charging
15-30amp alloy fast charger.
charger on board.
Ability to recharge on the move while driving from a gasoline generator.
Power Supply
Match the capacity to your needs: 1.6kWh or 2.6kWh.
Dual safety system – active and passive safety:
Active Safety:
> Battery management system (BMS).
> Real time performance and safety monitoring.
Passive Safety:
> IP66 rated sealed alloy enclosure.
> Vented enclosure with venting pathways.
> 30 Ah high safety lifepo4 cells.
Designed for disassembly at end of life.
Lighting
LED headlight:
> High quality lensed LED emitters.
> High beam – 2100lm, Low beam – 1200lm.
> Peripheral park lights.
Compact and lightweight.
Environmentally sealed.
Designed for disassembly at end of life.
LED rear, brake, and number plate lights.
Communication
Mobile management system:
> Integrates all electronic and electrical functions of the vehicle.
> Provides control and updates with Bluetooth 5.0.
Vented waterproof enclosure with sealed automotive connectors.
Isolated CAN bus for easier integration of future CAN devices.
CAN communication with power supply.
Vehicle Class
US – Motor driven cycle or moped
EU – L1e-B

Ultra Bike 2x2 Production